Drill Guide - Matkap Klavuzu

Drill Guide - Matkap Klavuzu için görsel

I'm making a drill guide a bit of plywood. Extremely handy tool for opening 90 degree holes. Also the cost is very low. After watching the video you can do according to your own drill.

Video :






Dimensions :

Unfortunately there is no plan. I hope the following images will help you to dimensions.

18mm plywood
drill-guide

5cm marking - cutting
drill-guide

2cm marking
drill-guide

for my drill - 48mm hole saw - (Width to fit your drill)
drill-guide

2x - 11cm cutting (M8)
drill-guide

6X - 36mm cutting (Øin 8mm, Øout 10mm metal)
drill-guide

3x 34cm (Øout 8mm metal)
drill-guide

3X - 6cm hardwood Ø 25mm - Drilling 8,5mm
drill-guide

drill-guide

54mm hole saw
drill-guide

Yorumlar

Sliding Angle Grinder Stand - PDF

Sliding Angle Grinder Stand - PDF

Start by downloading a PDF template from the link below. Print PDG dimensions table (this PDF). Then perform the operations on the video.

Haftanın Konusu testere

Second Part, Wooden Lathe Making Video and Dimensions (PDF)
It was a handy lathe machine. You can make this homemade lathe as a DIY project . I hope you enjoy the first part.
In this DIY video I am making Taper Jig - Jointer Jig for my tablesaw. I used some plywood.
Drill Guide - Matkap Klavuzu - Video & Dimensions konusunu görüntülemektesiniz.
 Sayfa başına dön